Key takeaway
Government eligibility splits into two classes. (1) No percentage bar — UPSC Civil Services, SSC CGL, and bank PO exams (SBI PO / IBPS PO) require only a graduation degree in any discipline; a CGPA that equates to a pass is enough. (2) Percentage bar — technical and PSU posts (ISRO, Railway JE, RBI Grade B, BHEL/ONGC) commonly demand 60–65% aggregate. Convert your CGPA with your university's formula; where none exists use ×9.5 (common) labelled indicative. Never submit a self-computed figure where an institute certificate exists.
Scope and assumptions
Conversion figures on these pages are indicative unless issued by your board/university or a credential evaluator (WES/ECE). For admissions, jobs, or immigration, confirm the exact formula and eligibility on the official notification (cbse.gov.in, vtu.ac.in, iimcat.ac.in, upsc.gov.in, ssc.nic.in, isro.gov.in, rbi.org.in, etc.) before submitting. This site is informational and not official.
Quick navigation
- General conversion guide → cgpa-to-percentage-guide
- Engineering jobs (placement % ) → cgpa-to-percentage-engineering
- MBA / CAT (50% floor) → cgpa-to-percentage-mba
- Reverse (percentage → CGPA) → percentage-to-cgpa
- 20+ FAQs → cgpa-to-percentage-faq
1. Myth-buster: most "gazetted" exams do NOT require 60%
A common belief is that every government job needs 60%. That is false for the biggest recruiters:
- SBI PO / IBPS PO — major portals and the official notifications state the basic requirement is a graduation degree in any discipline; there is no fixed minimum percentage. (Confirmed across jagranjosh / indgovtjobs summaries.)
- UPSC Civil Services (CSE) — a recognised graduation (pass) is the bar; no aggregate percentage required (
upsc.gov.in). - SSC CGL — graduation (pass) in any stream; no minimum % (
ssc.nic.in).
So if your only hurdle was "I have a CGPA, not 60%," check the exact post — you may already qualify.
2. Two classes — specific post table
| Post | Graduation bar | Verify on |
|---|---|---|
| UPSC Civil Services (CSE) | Pass (degree) | upsc.gov.in |
| SSC CGL | Pass (degree) | ssc.nic.in |
| SBI PO | Degree in any discipline | SBI notification |
| IBPS PO | Degree in any discipline | IBPS notification |
| ISRO (scientist/engineer) | ~65% aggregate (common) | isro.gov.in |
| Railway (RRB JE / technical) | ~60% aggregate (common) | rrbcdg.gov.in |
| RBI Grade B | ~60% (common) | rbi.org.in |
| BHEL / ONGC / other PSUs | 60–65% (varies) | respective PSU notification |
Because each notification is independent, read the specific post's percentage clause rather than assuming one national rule. Figures above are the commonly published ranges — always confirm on the official notification.
3. Convert with your university formula
When a notification says "60% in graduation," your CGPA becomes a percentage via:
- Your institute's printed formula (best — e.g. an exam-branch certificate), or
- ×9.5 (common) as a fallback, labelled indicative.
Examples:
| CGPA | % (×9.5) | Note |
|---|---|---|
| 7.0 | 66.5% | clears 60% |
| 6.4 | 60.8% | clears |
| 6.3 | 59.85% | just under — verify institute formula |
| 6.0 | 57.0% | below 60% |
4. The "throughout" trap
Some PSU posts demand a minimum percentage across all stages (10th, 12th, graduation). Two issues:
- They mean the issued percentage, not a self-estimate. If your marksheet is CGPA-only, get your university's official conversion.
- Backward-rounding near 60.0% can disqualify you on paper. Keep one decimal.
5. Don't confuse "pass" with a percentage bar
UPSC/SSC/bank PO say only "graduation pass" — there, a CGPA that equates to a pass qualifies. But the same graduate may later target a PSU that demands 60%; convert early so you know which doors are open.
6. Common mistakes
- Assuming 60% for every govt job — UPSC/SSC/bank PO need only a degree.
- Self-estimating where an institute certificate is required.
- Rounding up near a 60% boundary (6.3 CGPA = 59.85%, not 60%).
- Missing the "throughout" clause on PSU forms.
- Using ×9.5 on a university CGPA that has its own rule (e.g. VTU).
FAQ
Q: Which percentage do I enter in a govt form? The issued one; if CGPA-only, your university's official conversion.
Q: Do SBI/IBPS PO need 60%? No — they require a graduation degree in any discipline; no fixed minimum %.
Q: My CGPA is 6.3 — am I above 60%? 6.3 × 9.5 = 59.85%, just under. Verify with your real institute formula before relying on it for a PSU post.
Q: Is ×9.5 accepted by UPSC/SSC? Use it only when your university gives no formula, labelled indicative; the body may ask for an institute certificate.
Q: Does ISRO really need 65%? Commonly ~65% aggregate is published; confirm on the current isro.gov.in notification.
Q: Railway JE percentage bar? RRB JE technical posts commonly state ~60%; check rrbcdg.gov.in.
Q: RBI Grade B needs 60%? Commonly ~60% is published; verify on rbi.org.in.
Q: UPSC needs no percentage at all? Correct — a recognised graduation (pass) is the eligibility; no aggregate % bar.
Q: Can I use CBSE ×9.5 for my UG? Only if your university has no formula and you label it indicative; UG uses your university rule.
Q: What if my PSU form asks for "graduation %" but I have CGPA? Convert with your institute's formula and attach the source circular.
Sources: UPSC (upsc.gov.in); SSC (ssc.nic.in); SBI/IBPS PO graduation-in-any-discipline criteria (jagranjosh / indgovtjobs summaries); ISRO (isro.gov.in) / RRB (rrbcdg.gov.in) / RBI (rbi.org.in) official notification domains; common ×9.5 convention; institute conversion certificates.
Disclaimer: Conversion figures on these pages are indicative unless issued by your board/university or a credential evaluator (WES/ECE). For admissions, jobs, or immigration, confirm the exact formula and eligibility on the official notification (cbse.gov.in, vtu.ac.in, iimcat.ac.in, upsc.gov.in, ssc.nic.in, isro.gov.in, rbi.org.in, etc.) before submitting. This site is informational and not official.
Sources and references
- UPSC/SSC/PSU/ISRO official notificationshttps://upsc.gov.in/
- government job eligibility circularshttps://upsc.gov.in/